0 of 20 questions completed Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
0 of 20 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0) When a range of ports is being configured for EtherChannel, which mode will configure LACP so that it initiates the EtherChannel negotiation?
What is an advantage of using LACP?
Which command will initiate EtherChannel interface configuration mode?
Launch PT Hide and Save PT
Which three options must match in order to establish an EtherChannel between two directly connected switches? (Choose three.)
Which statement is true regarding the use of PAgP to create EtherChannels?
Which PAgP mode combination will establish an EtherChannel?
What is a best practice to use before beginning an EtherChannel implementation?
Which two protocols are link aggregation protocols? (Choose two.)
Which statement describes an EtherChannel implementation?
When a range of ports is being configured for EtherChannel by the use of PAgP, which mode will form the bundled channel only if the port receives PAgP packets from another device?
As the network administrator you have been asked to implement EtherChannel on the corporate network. What does this configuration consist of?
An EtherChannel link using LACP was formed between two switches, S1 and S2. While verifying the configuration, which mode combination could be utilized on both switches?
What is the most cost-effective method of solving interface congestion that is caused by a high level of traffic between two switches?
Which two load balancing methods can be implemented with EtherChannel technology? (Choose two.)
CCNA 3 Scaling Networks Chapter 3 v5.0 Exam
Quiz-summary
Information
CCNA 3 Scaling Networks Chapter 3 v5.0 Exam
Results
Average score
Your score
Categories
Pos.
Name
Entered on
Points
Result
Table is loading
No data available
1. Question
2 points
2. Question
4 points
Sort elements
3. Question
2 points
4. Question
2 points
5. Question
2 points
Open the PT Activity. Perform the tasks in the activity instructions and then answer the question.
What are two reasons why the ping messages that are issued from Laptop0 towards Laptop1 are failing? (Choose two.)
6. Question
3 points
7. Question
2 points
Refer to the exhibit. Which switching technology would allow each access layer switch link to be aggregated to provide more bandwidth between each Layer 2 switch and the Layer 3 switch?
8. Question
2 points
9. Question
2 points
10. Question
2 points
11. Question
2 points
12. Question
2 points
Refer to the exhibit. A network administrator has decided that an EtherChannel between ports 0/1 and 0/2 on switches S1 and S2 would help performance. After making the configuration, the administrator notices no performance gain. Based on the output that is shown, what two possible assumptions could a network administrator make? (Choose two.)
13. Question
2 points
14. Question
2 points
15. Question
2 points
16. Question
2 points
Refer to the exhibit. The administrator tried to create an EtherChannel between S1 and the other two switches via the commands that are shown, but was unsuccessful. What is the problem?
17. Question
2 points
18. Question
2 points
19. Question
2 points
Refer to the exhibit. An EtherChannel was configured between switches S1 and S2, but the interfaces do not form an EtherChannel. What is the problem?
20. Question
2 points
CCNA 3 Scaling Networks Chapter 3 v5.0 Exam
CCNA 3 Scaling Networks Chapter 3 v5.0 Exam
CCNA 3 Scaling Networks Chapter 3 v5.0 Exam
Mohmed Oudad
Good
bilguunbileg
thanks